Screeners
Carrier vibrating screeners are designed to screen, scalp, dewater, or separate dry or wet materials using a wide variety of screening media.
- Units feature a two-bearing design that provide a circular motion, increasing the screening efficiency. Ideally suited for wet or dry screening, these machines are available in single, double or triple deck designs with grease or oil lubrication bearing systems. Capacities range up to 1,500 tons per hour.
- Designed for the highest possible efficiency, Carrier screeners are also available with elliptical motion drives that can solve difficult screening problems. This motion provides a high rate of travel at the feed end, providing a thin material bed and rapid stratification which separates the fines quickly. At the discharge end, the material flow is retarded, giving near-size particles additional time to pass the screen. Capacities range up to 500 tons per hour.
- Tuned, two-mass, natural frequency and brute force designs available in widths from 6 inches to 10 feet and lengths up to 200 feet.
- Designed to accommodate up to five separate decks on a single unit.
- Available with side, end, intermediate, straight, or bias discharges.
- High temperature designs available for handling materials up to 2000 deg. F.
- Choice of construction from carbon steel to metal alloys.
- Options include removable dust-tight covers, overhead drive arrangement, liners, explosion-proof designs, etc.
- Available in fixed or adjustable rate designs.
- Supported from below or suspended from above on soft steel coil or rubber isolation springs to reduce dynamic reactions to surrounding structures.
- Easy installation, low maintenance, and minimum downtime.
- Economical in initial cost and operation.
For more information on Carrier screeners and feeders, refer to brochures #16906 and #16905.
